Linofog® Fix
Linofog® Fix
For damages and non moving joints
Linofog® Fix is a polyurethane based, 2-component material to be mixed with fine grain aggregate. Linofog® Fix is developed to enable quick repairs with short open time and quick drying time of approx 2-3 hours. Linofog® Fix is applied in thicknesses between 0-40 mm. Preferable, Linofog® Fix should be used as repair material for smaller damages and unlevel nesses. Please find Linofog® Fix chemical resistance and tests according to the below figures.
| Acid: | 10 % sulphuric acid 50 % phosphoric acid 50 % chromic acid |
Animal: | fat protein blood |
| Alkali: | 1 % caustic soda 1 % ammonia |
Vegetable: | fat protein sugar |
| Salt: | NaCl Na2CO9 10 % NaHCO9 |
Oil: | crude oil light oil lamp oil machine oil (mineral) |
The following tests have been run at the National Testing Institute in Japan (JIS)
| Surface material | Tensile strength N/mm2 | Elasticity module N/mm2 | Max flexibility % |
|---|---|---|---|
| Linofog® Fix | 5,3 | 29,8 | 18 |
| Epoxi | 58,3 | 2,9 | 2,2 |
JIS sample size: 13 x 13 x 150 mm, span 100 mm, test speed 3 mm/min.
Adhesiveness (N/mra2)
| Surface material | Primer | Steel | Stainless steel | Aluminium | Concrete |
|---|---|---|---|---|---|
| Linofog® Fix | no yes |
3,8 6,6 |
4,3 7,0 |
2,9 4,1 |
1,7 2,4 |
| Epoxi | no yes |
3,1 5,0 |
4,2 6,8 |
1,6 6,2 |
1,9 2,7 |
JIS K 6850 extension and scratch test
Abrasion test:
| Surface material | Revolutions | Wear result (abrasion) |
|---|---|---|
| Linofog® Fix | 400 1000 1500 |
low wear 0,1 mm 0,2 mm |
| Epoxi | 400 | 2 mm heat deformation from the beginning |
Laying instructions
1. Make sure that the surface is free from dust and moisture.
2. Apply Linoprimer evenly over the surface.
3. Let the Linoprimer dry for approx 3 hours (based on temperatures + 14-18 °C)
4. Mix 2,5 kg aggregate with 1,75 kg Linofog® Fix Base. Add the 0,75 kg hardener, mix to a smooth mixture (empty the hardener can thoroughly).
5. Apply the mixture with a hand trowel.
6. Let it harden for approx 2 hours (based on temperatures between + 14 -18 °C)
7. When more aesthetic demands are required, grind the joint with a fine grain sandpaper, first after 3-4 hours after application (based on temperatures between +14-18 °C)
Consumption
1 kg ready mixed material is enough for approx 1m2 and 1,8mm thickness.
Packaging
Linofog® Fix base 1,75 kg, Linofog® Fix hardener 0,75 kg, Linofog® Fix aggregate 2,5 kg = 1 set/5 kg/3 lit = 1 m2 and 9 mm thickness.
